Our Process (detailing)
We take pride in using top-of-the-line equipment and products to ensure your vehicle gets the safest, most effective clean possible — with a strong focus on both appearance and long-term protection.
The Whole Process
1. Wheel & Tire Cleaning
We start with the dirtiest part of the vehicle — the wheels.
-
We use a wheel face brush to clean the wheel surface,
-
A dedicated tire brush to scrub the tire sidewall,
-
A wheel brush to get deep into crevices, and
-
A barrel brush to clean inside the wheel barrels.
Once the wheels and tires are fully cleaned, we rinse them down.
2. Initial Rinse & Pre-Wash
Next, we rinse the entire vehicle to remove loose dirt and grime.
We follow that with an alkaline pre-wash, designed to safely lift embedded dirt and road film — minimizing the risk of scratching during the contact wash.
3. Foam & Contact Wash
Once the pre-wash is rinsed off, we apply a thick layer of pH-neutral foam across the entire vehicle.
-
We use a small detailing brush to clean in tight spaces like badges, window trim, and gas caps.
-
Then we perform a top-to-bottom hand wash using a high-quality microfiber wash mitt, which gently lifts remaining dirt without marring the paint.
4. Drying Process
After the contact wash, we thoroughly rinse and then dry the vehicle using a soft microfiber drying towel and a touchless blower to remove water from crevices, mirrors, and trim.
​
Platinum Package – Deep Decontamination & Protection
For clients choosing the Platinum Package, we go even further before drying:
-
We perform a full iron decontamination to remove embedded metallic particles from the paint.
-
Followed by a clay bar treatment to eliminate any remaining surface contaminants, leaving the paint glass-smooth.
-
Finally, we apply a premium paint sealant to enhance gloss, protect the finish, and promote water beading and long-lasting shine.
